Information and drawings
-
Refrigerant productRefrigerant, also known as refrigerant, refrigerant, and snow, is a medium used in various heat engines to complete energy conversion.These materials typically increase power with a reversible phase change, such as gas-liquid phase change. Such as steam in steam engines, snow in refrigerators, and sInformation and drawings April 23, 2019 -
Gas filling process and pointsFirst, the main points of permanent gas filling1. Professional training, certification, and compliance procedures2, wearing protective equipment, inspection equipment3. Review cylinders and check air tightness4, open the total valve, ready to inflate5, inspection when filling6, the discovery of theInformation and drawings March 22, 2019 -
Common classification of stainless steelStainless steel is generally classified into three types according to metallographic structure: austenitic stainless steel, ferritic stainless steel, and martensitic stainless steel. On the basis of these three basic auspicious organizations, for the specific needs and purposes, dual phase steel, prInformation and drawings March 18, 2019 -
Fire extinguisher type and scope of useFirst, the foam fire extinguisher1. At present, it is mainly chemical foam. In the future, air foam should be developed. The foam can cover the surface of the burning material to prevent air from entering. It is most suitable for fighting liquid fires, and cannot extinguish fires of water-soluble flInformation and drawings February 19, 2019
-
Precautions for installing the pressure reducing valveThe installation of the pressure reducing valve must be in accordance with the direction of the arrow on the valve body to maintain the direction of fluid flow. If the water quality is not clean and contains some impurities, the filter must be installed at the upstream inlet of the pressure reducingInformation and drawings January 29, 2019
-
Helium cylinder use instructionsDue to production needs, cylinders must be used on site (indoor), the number of which must not exceed 5 bottles, and should meet the following requirements:1. The room must be well ventilated to ensure that the maximum content of hydrogen in the air does not exceed 1% (volume ratio). A louver or venInformation and drawings January 29, 2019
-
Liquefied petroleum gas cylinders cannot be filledBecause each cylinder has a certain pressure. The liquefied gas is normally filled into the bottle in a liquid state at a normal temperature, and when the ambient temperature is raised, part of the liquid is converted into a gas to increase the pressure inside the bottle. Therefore, in order to ensuInformation and drawings January 08, 2019
-
Gas stove structureThe cooker is annular, and has a mixed gas injection port on the inner upper circumference; one end of the mixing pipe is connected to one side of the cooker, and the other end is provided with an air regulating port; the middle of the air regulating port is a gas input pipe; The air box is providedInformation and drawings December 29, 2018
-
Various gases in the airThe nitrogen content in the air is the most, and nitrogen is mainly used for ammonia synthesis, and is also an important raw material for synthetic fibers, synthetic resins, and synthetic rubber. Nitrogen can be used as a preservative, refrigerant, and can also be used to make fertilizers.Followed bInformation and drawings September 21, 2018
-
Oxygen cylinder use and precautions1. The gas in the oxygen cylinder cannot be completely used up, and the residual pressure of not less than 0.05MP should be retained.2. The distance between the oxygen cylinder and the open flame should be no less than 10 meters, should not be close to the heat source, and should not be exposed to sInformation and drawings September 12, 2018
